SET FEEDER SENSITIV 100 TELESCO

To assemble your Feeder Sensitiv 100 telesco kit, we'll guide you through each step in this tutorial video.

To assemble your crank:

1/ Secure the screw located on the frame opposite the crank
2/ Make sure that there are no gaps in the crank
3 / Turn the reel and make sure that it's working properly
opposite it.

In this video, we'll describe exactly how to set up your feeder rigging.

To clean your rod properly, you need to dismantle the entire assembly. Then, using a soft cloth soaked in warm water, gently wipe the surface. Once cleaned, leave to air dry before storing.

Storing your rod in a sheath is an essential step in protecting and preserving it over the long term.

In this video, we'll cover all of the important information on taking care of your reel.
Here, the video refers to a sea fishing reel, but the method is similar to the one used for a fresh water reel.

1/ Hold the reel in a horizontal position, with the brake tightened and crank screwed: Rinse in low-pressure fresh water (tap/shower) without immersing the reel in water!
2/ Make sure you rinse the spool really well (around 15 seconds)
3/ If needed, use a toothbrush to remove any dirt from hard-to-reach places
4/ Quickly turn the reel to get rid of excess water
5/ Remove the spool and dry it using a soft, dry cloth
6/ Add a drop of oil to any sensitive points (roller, axes, crank button, bearings on each side of the casing) then turn the reel
7/ Store in a dry place with the brake loosened
NB: Be careful when using anti-grip products such as WD40, as they also remove the grease and require careful re-lubrication (see "Greasing your reel")

Identify the broken section and order a new one online or in-store.
To do this, find the product you own in the block below and click on the corresponding tab.

For optimal repairs of your rod tip, follow the steps in our tutorial video.

1/ Unscrew the screw opposite the crank
2/ Remove the screw, then the crank
3/ Install the new crank
4/ Fasten the screw in the hexagonal axis of the opposite side

1/ Unscrew the brake button and remove it
2/ Remove the spool from the axis (without removing the washers placed below it)
3/ Position the new spool onto the axis, turn it in on itself until it clicks into place
4 / Re-screw the brake button (taking care to ensure that the brake button is correctly position to avoid damaging the screw thread)

1/ Unscrew the brake button and remove it.
2/ Take the new brake button and screw it back in (taking care to ensure that the brake button is correctly positioned to avoid damaging the screw thread).