TF 160

8043929

Year of commercialization: 2007

I have a problem

THE CONSOLE WON'T SWITCH ON

The treadmill is not connected correctly

 

 

           => Check the connection of the mains socket, then make sure that the treadmill's main switch is set to \"1\"
           => Then check that the safety key is in position
           => Check and press the circuit-breaker if it has tripped

LUBRICATING THE RUNNING BELT

The belt is dry:

 

 

           =>Lubricating the running belt
           =>If the belt is dry, spray silicone as shown on the pictures
           2 pulverizations on each side is enough
           
           =>Let the treadmill run for 5 minutes to allow the silicone to spread on the whole belt
 
           => It is important to perform this operation regularly (every 10 hours of use) in order to get the maximum lifespan from your treadmill

 

CENTERING THE RUNNING BELT

The treadmill belt is off-centre

 

 

First step :
Use the Allen key provided with your product
 
Second step :
1 - Run your treadmill at 4 km/h
 
2a - If the belt if off-centre to the left, turn the left-hand adjusting bolt a quarter of a turn clockwise.

 
2b - If the belt is off-centre to the right, turn the right-hand adjusting bolt a quarter of a turn clockwise.
 
3 - Let the treadmill run a few seconds for the belt to reposition itself
 
4 - Repeat the procedure if necessary

MY TREADMILL IS NOISY

The screws are loose

           => Tighten all the screws in the uprights

 

The running belt is not centred

           => Refer to chapter \"Centering the running belt\"

 
 

The running belt is not properly lubricated
           => Refer to chapter \"Lubricating the running belt\"

 

THE TREADMILL SPEED IS NOT CONSTANT

Check that the running belt is correctly tightened

 

           => Refer to chapter \"Adjusting the tension of the running belt\"

 

RUNNING BELT TENSION

 

Stage 1:
Use the Allen (hex) key provided with your treadmill
 
Stage 2:
1) Press the \"GO\" button
 
2) Increase the speed up to 5 km/h
 
3) Turn the two adjustment screws one quarter turn clockwise
 
4) If needed, repeat stage 3

YOUR TREADMILL DISPLAYS AN ERROR CODE E...

Click \"NO\"

Manual and software

You can not solve the problems or to find your answer, we invit you to contact us
TOP OF PAGE