TC 140

The treadmill is not connected correctly
 
 
           => Check the connection of the mains socket, then make sure that the treadmill's main switch is set to \"1\"
           => Then check that the safety key is in position
           => Check and press the circuit-breaker if it has tripped

The belt is dry:
 
 
           =>Lubricating the running belt
           =>If the belt is dry, spray silicone as shown on the pictures
           2 pulverizations on each side is enough
           
           =>Let the treadmill run for 5 minutes to allow the silicone to spread on the whole belt
 
           => It is important to perform this operation regularly (every 10 hours of use) in order to get the maximum lifespan from your treadmill
 

The treadmill belt is off-centre
 
 
First step :
Use the Allen key provided with your product
 
Second step :
1 - Run your treadmill at 4 km/h
 
2a - If the belt if off-centre to the left, turn the left-hand adjusting bolt a quarter of a turn clockwise.

 
2b - If the belt is off-centre to the right, turn the right-hand adjusting bolt a quarter of a turn clockwise.
 
3 - Let the treadmill run a few seconds for the belt to reposition itself
 
4 - Repeat the procedure if necessary

The screws are loose
           => Tighten all the screws in the uprights
 
The running belt is not centred
           => Refer to chapter \"Centering the running belt\"
 
 

The running belt is not properly lubricated
           => Refer to chapter \"Lubricating the running belt\"

 

Check that the running belt is correctly tightened
 
           => Refer to chapter \"Adjusting the tension of the running belt\"
 

 
Stage 1:
Use the Allen (hex) key provided with your treadmill
 
Stage 2:
1) Press the \"GO\" button
 
2) Increase the speed up to 5 km/h
 
3) Turn the two adjustment screws one quarter turn clockwise
 
4) If needed, repeat stage 3