TL100 TORCH - 100 lm: instructions, repairs, maintenance advice

When the battery reaches a very low level, the lamp automatically lowers the power so that it keeps working for another hour at 50 lm.

An indicator light on the top of the headlamp lets you know the battery's level of charge within seconds of switching it on.

> Green = between 50% and 100%
> Red = less than 30%

Press for two seconds to lock the torch.

Then press for 2 seconds to unlock it.

This mode allows you to navigate or get around in a very short range with a less dazzling colour for those who are nearby. This light also makes it possible to lower nocturnal acuity (ability of the eye to see in the dark).
The red mode is therefore popular in refuges, in tents or in groups, but also for star lovers.

It is important to store the lamp in a place protected from direct sunlight and humidity. During long-term storage, remember to remove and fully recharge the battery (every 6 months).

The headband is removable and washable. You can wash it with soap and water. 
You can also clean it using a humid cloth.

Unlike conventional light bulbs that could be easily unplugged, LED technology does not allow them to be replaced because they are soldered to the electronic board. The LEDs we use, on the other hand, have a very long lifespan which ensures you use them for several years without any worries.

Headlamps are subject to the provisions for the recycling of electrical and electronic products (e-waste). At the end of its life, you can bring your headlamp back and deposit it in the recycling bins at the entrance to our DECATHLON stores.

Unlike watts, which express the energy consumption of an electrical device, lumens correspond to the quantity of light actually emitted by the lamp.
This measurement is carried out by placing the lamp in an enclosure fitted with sensors and measuring the light emitted in all directions around the lamp.
PLEASE NOTE! At equal power, all the lamps will not have the same lighting range because it will depend on how concentrated the beam at the exit of the lamp is (with a lens or a diffuser).
The narrower the beam, the farther the lamp will illuminate.
The wider the beam, the better the lamp will illuminate the sides evenly, but to the detriment of the range.

If the lumens correspond to the light emitted by the lamp in all directions, the lux corresponds to the light received locally at a point illuminated by the lamp. This illuminance unit therefore makes it possible to measure the lighting distance of each lamp.

The maximum power of a lamp is measured in the first 2 minutes of lighting up, new batteries (or fully recharged).
On some models offering temporary modes (Boost modes), it corresponds to the power of this mode.

According to the ANSI-FL1 standard, all the lighting ranges of Decathlon products correspond to the distance at which the lamp can illuminate at 0.25 Lux.
This value corresponds to the illumination received by the moon under ideal conditions (clear weather, full moon).

For each lighting mode, the autonomy corresponds to the time during which the lamp is capable of supplying 10% of the maximum power of this mode.