VM 120

The pedals are not tight enough
 
            =>Loosen the pedals 1 tour and tighten them back up as hard as possible
 

1. Assembly problem
=>At the back of the console
Refer to the instructions to check that the console has been connected correctly

=>At the connection between the two tubes
Refer to the instructions to check that the cables have been connected correctly

 
2. Electrical problem
=>Your bike works with batteries
Check that the batteries are properly positioned with the correct +/- polarity. If the problem persists, start again with new batteries

=>Your bike is plugged into the main socket
Check if the adaptor is correctly connected to the bike and plugged into the main sokcet and make sure that it works
 
3. Problem in use
Information: the console will not switch on if you are using batteries and the mains power at the same time

1. I can't assemble the pedals
 
           => Assembly problem
Make sure to use the right pedal (marked with \"R\") on the right side and the left pedal (marked with \"L\") on the left side
 
2. I hear a noise when pedaling
 
           => Make sure that all pedales have been properly mounted
Make sure that all washers have been properly mounted (as per the instructions) and that all screws are tight enough
 
 

The screws are loose
 
           => Tighten all visible screws
 

1. I can't adjust the level of resistance
 
            => The cable is not properly connected
Disassemble the handlebar post and check that the cable is properly connected
 
           => Make sure the black plastic block on the lower cable has been removed
 
2. The 1st level of resistance is abnormally hard
 
           => The cable is not properly connected
Disassemble the handlebar post and check that the cable is properly connected

 Look for the number of the part and click ’NO’
 
 

Calibration problem
 
           => Check that the switch at the back of the console is in the position MI for miles and KM for kilometres
Press RESET to validate

The console displays \"FAT\" and \"Err 2\"
 
 
           => Make sure the palm of your hand is wrapping around both plates of the pulse sensor
           => Make sure your hands aren't too wet
           => When 'HOLD' appears in the display, immediately hold the sensors

The heart rate indicator is not flashing or flashes erratically
=>Check that the heart rate monitor belt is properly positioned (check the heart rate monitor's instructions)

 

 
Edit the values: turn
Edit the functions: press
 
 

I hear a noise when pedaling
 
           => Make sure that all pedales have been properly mounted (as per the instructions)
 

-