I have a problemMY CONSOLE DOESN'T TURN ON1. Assembly problem=>At the back of the consoleRefer to the instructions to check that the console has been connected correctly =>At the connection between the two tubesRefer to the instructions to check that the cables have been connected correctly 2. Electrical problem=>Your bike works with batteriesCheck that the batteries are properly positioned with the correct +/- polarity. If the problem persists, start again with new batteries =>Your bike is plugged into the main socketCheck if the adaptor is correctly connected to the bike and plugged into the main sokcet and make sure that it works 3. Problem in useInformation: the console will not switch on if you are using batteries and the mains power at the same time I'M HAVING A PROBLEM WITH THE LEVEL OF RESISTANCE1. I can't adjust the level of resistance => The cable is not properly connectedDisassemble the handlebar post and check that the cable is properly connected => Make sure the black plastic block on the lower cable has been removed 2. The 1st level of resistance is abnormally hard => The cable is not properly connectedDisassemble the handlebar post and check that the cable is properly connectedMY BIKE MAKES A CLICKING NOISE ON EVERY PEDAL TURNThe pedals are not tight enough =>Loosen the pedals 1 tour and tighten them back up as hard as possible MY BIKE MAKES NOISEThe screws are loose => Tighten all visible screws I HEAR A NOISE WHEN PEDALINGI hear a noise when pedaling => Make sure that all pedales have been properly mounted (as per the instructions) I 'M HAVING A PROBLEM WITH THE PEDALS1. I can't assemble the pedals => Assembly problemMake sure to use the right pedal (marked with \"R\") on the right side and the left pedal (marked with \"L\") on the left side 2. I hear a noise when pedaling => Make sure that all pedales have been properly mountedMake sure that all washers have been properly mounted (as per the instructions) and that all screws are tight enough MISSING PARTS OR BROKEN COMPONENTS Look for the number of the part and click ’NO’