ONMOVE 510

1 - Make sure you have the latest version of the ONconnect software.
2 - Once you've plugged your watch into your computer, check to see that the device is recognized on your desktop.

Otherwise:
2.1 Check the metal contacts at the back of your watch for signs of corrosion. If they are corroded, clean them with alcohol or vinegar and a cotton swab. Also check that the clip is correctly positioned on your watch.

2.2 Reinstall product drivers
2.2.1 On your computer, go to the Control Panel, System tab, then open the Device Manager.
2.2.2 Open the disk drive tab and right click on "STM STR Flash Disk USB Device," corresponding to your device and select Uninstall. Your device will no longer be recognised.
2.2.3 Unplug and then plug in your device; the drivers will automatically reinstall and you will see the following pop-up window:
2.2.4 Check that the product has been recognized in the Device Manager as well as the Desk top.

3 - If you're still experiencing difficulty, please contact one of our support technicians directly via the "Contact" page at the bottom of this website.

1. Make sure the cable is properly connected to your watch and computer.
2. Make sure you use a micro-USB cable capable of data transfer. Some micro-USB cables can only be used for charging. These can be identified by a lightning bolt icon on the cable.
3. Make sure you have the latest version of ONconnect

However, if you're still experiencing problems, please contact our Support team via the "Contact" page at the bottom of this website.

Satellite signal reception quality is considerably impacted by the environment and your movement.
To facilitate reception, we recommend the following during signal detection:

1. Positioning yourself in a clearing away from buildings and trees.
2. Place your watch on a table or on the ground.

In fact you can buy the ANT+ belt, which is compatible with this device, from our Decathlon stores; this will allow you to enjoy all the practical cardio features offered by your watch.

Your GPS watch's sampling rate range varies from between 1 point every second to 1 point every 5 seconds. The lower the sampling rate, the greater the storage capacity. However, route mapping will be less accurate. You can adjust the frequency setting in the "Library/Product Memory" menu. The default setting is 2 seconds.

The sensors at the back of your watch may have become corroded due to perspiration.

Clean them with alcohol or vinegar and a cotton swab.
Also check that the clip is correctly positioned on your watch.

Your watch has a waterproof rating of IPX7. This means that it is designed to withstand heavy rain, accidental splashes and immersion, but is not designed for swimming or water sports.

where can I get another?

Your watch is fitted with a piston strap. To help you change it, here is a video example :

If your product cannot be repaired, return it to a WEEE collection point or any DECATHLON store to optimize recycling.